Harness processing assembly need to pay attention to the problem

Automotive wiring harness processing in the assembly process, you need to follow certain principles, for this reason, wiring harness assembly need to pay attention to the following points:

1, when the harness assembly, do not pull too tight, so you can prevent the vehicle and then bumpy state, causing the wire harness fixed point of displacement, resulting in the distance between the two fixed points increases, stretching the harness so that Caused by the internal wiring harness virtual connection or pull off, the wire parameters change, it will pull off the wire if serious.

2, wiring harness in the assembly is completed, the surrounding must be left with enough clearance to pass, to ensure that will not be other parts of the pressure or trip over. Avoid wire harness insulation breakdown, cracked or pinched off, causing ground faults and more.

3, do not close to the location of the layout of the same color and type connectors, so you can prevent misassembly when assembled, damage to electrical appliances and wiring harness situation.

4, the connector to be arranged in easily found place, arranged in the tools and hands easy to operate place, so mainly for the convenience of inspection and maintenance, according to the actual assembly to consider the length of the wire. If the electrical device is installed in an easy-to-use place, it can eliminate the need to directly connect the connector to the component; if the location of the electrical device is relatively invisible, the later inspection and repair can be more difficult. According to the specific needs of the electrical components of the appropriate increase in the length of the wire, so that the plug-in arrangements for easy inspection and maintenance of the place.