Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

Detection before the use of PC control method. That is, both of them can enter into the detection state after the start, otherwise, the green light blinks waiting to start. The procedure is programmed with the main control instruction; the harness detection process towel automatically determines the type of the detection harness after the harness is inserted and triggers the detection pulse to detect the harness, Detection data stored in the data register, the detection speed can be changed by changing the data register, the value of the adjustment; cylinder action depends on whether the harness plug is inserted in place, when the harness is inserted in place, the limit switch is actuated, the cylinder clamping of the harness , The detection delay after loosening; instructions and alarm is used when the host computer analysis of the detection harness, if the wiring harness is qualified auxiliary relay, turn on the green light, otherwise it will set, light red and turn on the buzzer Call the police.

The key to adapting technology is the design of the adapter, the assignment of internal points, the alignment, and the adaptability to the identification of the harness tester. The core components of the adapter is the interface plug-in components, plug-in components should be easy to handle, identify clear, reliable contact characteristics. Plug-in components used as adapters fall into four categories: wire spring connectors, aviation plugs, quick docking components, and rectangular connectors. The adapter used as an adapter is ideal for quick docking components, integrated design, but the cost is too high, the choice of careful consideration to exclude, wire spring connector is the ideal device. Another key technology in adapter design is the distribution of points within the interface assembly, which is the exact, unique connection to the harness tester.

The impact on the dynamic performance of the system increases, the rapidity of the system deteriorates, the stability of the system increases and decreases, and the rapidity of the system becomes better and the stability deteriorates. So the choice should take into account the speed and stability. The control time domain indicates the number of changes to the future control volume to be determined. Increase and decrease the effect is similar, so the choice can be determined to re-adjust, and to make less than or equal to.