Shanghai Richeng Electronics Co. Ltd - ISO9001/IATF16949/ISO/TS22163
Choose Language

Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

Rainproof distribution cabinet basic introduction

Rainproof distribution cabinet is widely used in hotels, apartments, high-rise buildings, ports, stations, airports, warehouses, hospitals and factories and mines and other units of architectural lighting and small power control circuit for AC 50hz, AC single-phase 240v, three Phase 450v and below, the current 250a and below the indoor lighting and power distribution lines, as line overload protection, short circuit protection and line switching, the type of equipment suitable for civil or suitable for non-professionals can enter the site applicable. Products meet the "low-voltage switchgear" standard requirements.
Features:
      Box design will be safe part of the live cover, switch handle exposed cover, you can operate outside the box, open the lid can be overhauled, the lid is also installed on the small door;
The distribution box is equipped with a neutral terminal (or copper) and a ground protection line (or copper) corresponding to the output circuit;
Box into and out of the hole for the knock hole, distributed in the box on the lower end, but also according to user requirements open waist long hole, sealed with a cover;
Wall mounted and embedded wall concealed box size is basically the same, the difference is that the dark box panel than the box size slightly larger than the box;
Conditions of Use:
      The ambient air temperature is not higher than +40 ℃, not less than -5 ℃, and the average temperature within 24 hours shall not be higher than +35 ℃, over time, according to the actual situation derating run;
Indoor use, the use of altitude should not exceed 2000m;
The ambient air relative humidity is not more than 50% at a maximum temperature of + 40 ° C and a relatively large relative humidity at a lower temperature, such as 90% at + 20 ° C, taking into account the possibility of Will occasionally produce the effect of condensation;
Should be installed in places where there is no severe vibration and shock and is not sufficient to cause electrical components to be protected from corrosion.

Related articles

Previous: The composition and function of the harness
Next: Basic technical requirements for electric vehicle wiring harness
On-line
contact
message
download
Print
WeChat WeChat
Collection
TOP